Main Page

Short tutorial (under construction) on the setup and testing of a UART message using the Dev Interface 2.0 board. This is mostly to get new students up to speed quickly on how to use the Development Interface Board. See my AT90CAN/FreeRTOS new users tutorial for how to set up Atmel Studio etc.

Dev Interface setup for Async serial communication with uC over UART0

Sample usage: Import Interface module, Configure COM4 port 76800 baud, Configure GPIO pins for output, send all 1's to GPIO pins, Read GPIO pins, run receive handler (bit of python code left to massage. Need to read buffer a couple of times to get data values onto terminal)

Configure GPIO as outputs

Set GPIO to all 1's

QR Code
QR Code tutorial:uart_setup (generated for current page)